Insulation industry news from Global Insulation
China: An investigation by non-government agency the Environmental Investigation Agency (EIA) has found that trichlorofluoromethane (CFC-11) is being widely used as a blowing agent in the rigid polyurethane (PU) foam insulation sector. The EIA contacted 25 precursor or foam producers and found that 18 of these plants were using CFC-11 in 10 different provinces.
In May 2018 the journal Nature revealed that CFC-11 emissions had increased by around 25% since 2012 despite reported production being close to zero in 2006. CFC-11, other chlorofluorocarbons (CFCs) and substances that damage the Ozone Layer were banned under the Montreal Protocol from 2010.
The EIA speculates that widespread use of CFC-11 by Chinese PU foam producers may be the source of the reported rise of emissions. It estimates that up to 3500 small and medium sized companies could have switched to using CFC-11 following a reduction in the supply of HCFC-141b, an alternative blowing agent, and lax enforcement of the ban on CFC-11. One company representative the EIA spoke to said that HCFC-141b was US$150/t more expensive than CFC-11.
“This is an environmental crime on a massive scale. How the Montreal Protocol addresses this issue will determine whether it continues to merit its reputation as the world’s most effective environmental treaty,” said Climate Campaign Leader Clare Perry.
The EIA has released its report ahead of the Open-Ended Working Group of the Montreal Protocol meeting in Vienna in mid July 2018.
Canada: An Owens Corning fiberglass insulation plant in Edmonton has been ordered to monitor its emissions following a fire in early January 2016. The fire on 4 January 2016 damaged the plant's secondary air scrubber on its insulation batting production line.
Without the second scrubber the plant is contravening its Environmental Protection and Enhancement Act approval. A remedial solution to replace the curing oven's secondary air scrubber could take more than six months to implement.
As part of an enforcement order Owens Corning must monitor and notify Alberta Environment and Parks of any significant deviation from normal performance of the primary air emission scrubber on the curing oven. If the plant exceeds any air emission limits then production must immediately stop. Additional monitoring on the curing oven stack, including manual stack surveys, and an approved ambient air-monitoring plan are also required.